10
[
∗
]+[8]+[Installer’s Code]: Installer’s Programming Command
The PC560 is programmed from the keypad by using commands in the [
∗
][8][Installer’s Code] section.
These commands are described in detail in the Programming Section of this manual. The default Installer’s
Code is [0560].
[
∗
]+[9]+[Access Code]: At-Home Arming
Entering [
∗
][9] before entering an Access Code will arm the panel and remove the Entry Delay from the Delay
Zones. All “Stay-Away” zones will be automatically bypassed.
When the system is armed using the [
∗
][9][Access Code] command, the “Armed” light will FLASH to remind
the user that the Entry/Exit zones do not have the Entry Delay. This command allows the user to remain on
the premises and have an instant alarm on the entry doors.
Keypad Zones
Three types of alarm may be activated by pressing and holding a single key on the keypad. For these alarms
to be transmitted, Alarm Reporting Codes must be programmed in Section [13].
[F] Press and hold the [F] Key for 2 seconds to sound an [F] Key alarm. The siren will sound a pulsed
tone, and the alarm will be reported to the monitoring station. The keypad will sound a series
of short beeps once the system has accepted the alarm.
[A] Press and hold the [A] Key for 2 seconds to generate an [A] Key alarm. An alarm will be
transmitted to the monitoring station, but the siren will not sound when this function is activated.
The keypad will sound a series of short beeps once the system has accepted the alarm.
[P] Press and hold the [P] Key for 2 seconds to generate a [P] Key alarm. An alarm will be transmitted
to the monitoring station. The [P] Key alarm may be programmed as either silent or audible; refer
to Programming Section [05]. When programmed as “audible”, the bell or siren will sound a steady
alarm tone and the keypad will sound a series of short beeps once the system has accepted the
alarm. When programmed as “silent”, the bell or siren
will not sound
on alarm and the keypad
will not beep
to indicate that the system has accepted the alarm.
Adjusting the Keypad Sounder Tone and Backlighting
The sounder tone and the lighting behind the keys for each Keypad may be individually adjusted. The sounder
tone may be set with a loud tone, a softer tone, or no tone at all. The backlighting can be set at medium or high
brightness, or it may be turned off.
To adjust the Keypad’s sounder, press and hold the [#] Key; after two seconds, the sounder will begin to beep.
With each beep, the tone of the beep will increase or decrease. When the desired tone is achieved, release
the [#] Key.
To adjust the Keypad’s backlighting, press and hold the [
∗
] Key. The zone and status lights will be shut off,
and the Keypad will beep as each of the three backlighting levels is shown: medium, high and off. When the
desired level is reached, release the [
∗
] Key. Press the [#] Key to return to the “Ready” mode.
If all power to the system is shut off, each Keypad’s tone and backlighting will be restored to the factory settings.
WWW.DIYALARMFORUM.COM
(20 pagine)
(8 pagine)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commenti su questo manuale